Toyota

All of our Toyota 22RE engines are remanufactured by Sunwest Automotive Engines in Washington State. Our engines comes with ALL NEW; pistons and rings, rod and main bearings, oil pump, timing components (metal guides), timing cover is milled to the deck of the block, a full gasket /seal kit to complete your installation, a new cylinder head casting, an RV camshaft, professionally done machining on superior equipment, and assembled with pride.

Every engine comes with 30 month, 30,000 mile warranty. New water pumps available for $35.00. $500.00 refundable upon inspection core charge. We ship everywhere for a modest charge. Other Toyota engines are available!
This engine fits 1985-95 Toyota cars and trucks (fuel injected or carbureted).

Shop Now

List of new parts installed in these engines:

New NPR Hyper-Eutectic pistons with rings
New Kind Rod Bearings
New King Main Bearings
New Thrust Bearings
New Pin Bushings
New H.D. Timing chain set (w/ nylon coated steel rub rails)
New timing cover that is milled to the deck surface of the block
New Oil Pump

Full Gasket Set Included (All Gaskets Needed to Re-install Engine)
Valve Springs Are Checked and Replaced If Needed
Valves and Valve Guides are Checked and Replaced if Needed
New Viton Valve Seals Installed
New Delta RV (260 Grind) Camshaft Installed (Supreme Only)
New Brass Soft Plugs and Oil Galley Plugs Installed in Block
Reman Rocker Arm Assembly
Engine is pre-run on our sim test machine. You will get a print out of the actual oil pressure, oil flow, compression and engine load of your engine.

You will be e-mailed with all the torque specifications for the engine along with all the freight information.

Machining process performed on engine:

Engine and head is cleaned all bolt holes checked and repaired
Surfaces are checked and milled if needed
Blocks are bored and honed
Rods are reconditioned and pin bushing installed new
Crank shaft is ground and polished
Cylinder head is pressure tested, cam line is checked, all bolt holes taped and repaired if needed. We check the thickness of the heads all within the factory specs, heads 3-angel cut on a serdi machine and milled with a CBN mill

Valves will be adjusted, and engine will be set on T.D.C. #1
Timing covers are installed on bare block and milled with the deck to ensure a perfect fit.
New oil pump will be installed and primed.