Toyota

All of our Toyota 22RE engines are remanufactured by Sunwest Automotive Engines in Washington State. Our engines comes with ALL NEW; pistons and rings, rod and main bearings, oil pump, timing components (metal guides), timing cover is milled to the deck of the block, a full gasket /seal kit to complete your installation, a new cylinder head casting, an RV camshaft, professionally done machining on superior equipment, and assembled with pride.

Every engine comes with 30 month, 30,000 mile warranty. New water pumps available for $35.00. $500.00 refundable upon inspection core charge. We ship everywhere for a modest charge. Other Toyota engines are available!
This engine fits 1985-95 Toyota cars and trucks (fuel injected or carbureted).

List of new parts installed in these engines:

  • New NPR Hyper-Eutectic pistons with rings
  • New Kind Rod Bearings
  • New King Main Bearings
  • New Thrust Bearings
  • New Pin Bushings
  • New H.D. Timing chain set (w/ nylon coated steel rub rails)
  • New timing cover that is milled to the deck surface of the block
  • New Oil Pump
  • Full Gasket Set Included (All Gaskets Needed to Re-install Engine)
  • Valve Springs Are Checked and Replaced If Needed
  • Valves and Valve Guides are Checked and Replaced if Needed
  • New Viton Valve Seals Installed
  • New Delta RV (260 Grind) Camshaft Installed (Supreme Only)
  • New Brass Soft Plugs and Oil Galley Plugs Installed in Block
  • Reman Rocker Arm Assembly
  • Engine is pre-run on our sim test machine. You will get a print out of the actual oil pressure, oil flow, compression and engine load of your engine.

You will be e-mailed with all the torque specifications for the engine along with all the freight information.

Machining process performed on engine:

  • Engine and head is cleaned all bolt holes checked and repaired
  • Surfaces are checked and milled if needed
  • Blocks are bored and honed
  • Rods are reconditioned and pin bushing installed new
  • Crank shaft is ground and polished
  • Cylinder head is pressure tested, cam line is checked, all bolt holes taped and repaired if needed. We check the thickness of the heads all within the factory specs, heads 3-angel cut on a serdi machine and milled with a CBN mill
  • Valves will be adjusted, and engine will be set on T.D.C. #1
  • Timing covers are installed on bare block and milled with the deck to ensure a perfect fit.
  • New oil pump will be installed and primed.

Our Toyota engines are sold on a core exchange basis. We need your old core back within 30 days.

We accept all major credit cards-visa MasterCard AmEx discover, cashier’s checks, money orders and pay-pal.

Engines are sent out in box strapped to pallet the weight is 250 lbs